Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Uploading the iControl Edge Configuration Spreadsheets
110
2. Select the custom logo files (GIF or PNG) on your PC or laptop, and then drag them to the
Logos directory on the Application Server.
3. Close WinSCP.
Uploading the iControl Edge Configuration Spreadsheets
You can use any suitable file transfer application—WinSCP, for instance, or the upload function
of the Application Server’s File Manager utility—to transfer updated spreadsheets from your
client PC or laptop back to the Application Server.
To upload the configuration spreadsheets to the Application Server
1. Launch WinSCP, log on to the Application Server and navigate to:
/var/tomcat4/webapps/icw/sites/EDGE/Spreadsheets/
See "Downloading the iControl Edge Configuration Spreadsheets", on page 82.
2. Select the modified spreadsheet (
.xls) files on your PC or laptop, and then drag them to
the Spreadsheets directory on the Application Server.
See also
For more information about logo files, see "Services Worksheet", on page 99.