Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
109
2. Select the new or modified configuration files (.conf) on your PC or laptop, and then drag
them to the GC100 directory on the Application Server.
3. Close WinSCP.
You have successfully uploaded the configuration files for your GC-100 Network Adapter.
Uploading Custom Logo Files
Your iControl Edge system ships with a set of predefined logo files located under
/var/tomcat4/webapps/icw/sites/EDGE/images/Logo on the Application Server. You can
add custom logo files to this directory.
To upload custom logo files to the Application Server
1. Launch WinSCP, log on to the Application Server and navigate to:
/var/tomcat4/webapps/icw/sites/EDGE/images/Logo.
Note: When you update your system with a new version of the iControl Edge
package, any existing logo file that is not part of the default logo set, or that is more
recent than a logo file with the same name within the default set, will be carried
forward. Nevertheless, it is always advisable to keep a backup copy of your custom
logo files (e.g. on your hard drive).