Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
107
8. Click the Config tab.
9. In the KEY column, type
inheritance.
10. In the VALUE column, type
YES.
11. Save the spreadsheet and upload it to the head-end Application Server (see page 110).
12. Perform the following sub-steps for each instance of Densité Manager you would like to
manage from your head-end Application Server:
a) Open the Configuration spreadsheet of the hub Application Server.
b) Click the Devices tab.
c) In the APPLICATION SERVER section, in a new row, type the following information
corresponding to the head-end Application Server:
• ID:
<ApplicationServerID>
• TYPE: AS
• ENABLE: YES
• IP: <IPaddressofhead‐end>
• HOSTNAME: <hostnameofhead‐end>
d) In the DENSITE section, locate the Densité you would like to manage on the head-end,
and then type the ID of the head-end Application Server in the APP SERVER ID column.
e) Save the spreadsheet.