Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
103
To define the alarms covered by your iControl Edge configuration
1. Click the Alarms tab.
2. If desired, change the ALARM NAME—this will change the text displayed in the monitoring
application.
Config Worksheet
The Config worksheet defines alarm behavior, and other options.
Table 3-7, below, describes the worksheet contents:
ALARM TYPE The type of alarms (TEXT, STATUS).
LEVEL Specifies whether the alarm belongs to the Device or Service category. An alarm set to the
SERVICE
level is visible in the service’s alarm panel, and its state contributes to the overall alarm status for this
service. The service’s button color in the Channel Selector area represents this overall alarm status.
An alarm set to the
DEVICE level is also visible in the service’s alarm panel, but its state does not
contribute to the alarm status for this service (and thus does not affect the color of the corresponding
Channel Selector button).
1. Rows you wish to leave empty must include the two asterisks in this column.
IMPORTANT: Do not change the value for ALARM URI.
Note: If you wish to discontinue monitoring for a specific alarm, insert two asterisks
(
**) in the first column of the corresponding row, or delete the entire row. The alarm
will be removed from all Alarm Panels and will no longer be calculated or displayed.
Table 3-6: Alarms worksheet contents (
Conti nued
)
Column Description