Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
iControl Edge
Installation and Setup Guide
101
To define the services at this location
1. Click the Services tab.
2. For each service, specify a unique ID, the associated channel number, a short name, and a
long name.
3. Insert a description (using HTML tags where appropriate), and specify the logo file name.
4. Specify a cycling path and a manual path for this service, and identify a recordable service,
as required, by typing
YES in the RECORDABLE column.
5. Adjust the positioning of the Channel Selector buttons by changing the LOGICAL GROUP
value.
6. Define an alternative grouping of the Channel Selector buttons by typing the desired
group names under ALTERNATE GROUP ID.
7. For each service, specify if e-mail notification of service overall status is required (
YES, NO).
Alarms Worksheet
iControl Edge shows current alarm statuses in different ways: in the Channel Selector area,
the color of a Channel Selector button represents the corresponding service’s overall alarm
status; the alarm panel for a service displays more detailed alarm status information.
Note: The short names appear on the Channel Selector buttons. On a typical
system, the Channel Selector buttons can fit approximately 8 characters. Longer
names may appear truncated.
Notes
• Custom logo files can be uploaded to the following location on the
Application Server:
/var/tomcat4/webapps/icw/sites/EDGE/images/Logo
• The logo images provided with the package are 52 pixels wide × 32 pixels
high, but other dimensions up to 104 pixels × 64 pixels are also supported.
• A 13:8 ratio will best fit the space available for the logos in the iControl Edge
user interface.