Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Paths Worksheet
98
To define the signal paths for this site
1. Click the Paths tab.
2. For each path, specify a unique ID, and the TYPE of device being used in the path
(
STB_CYCLING or STB_MANUAL).
3. Specify the associated IR CONTROLLER ID.
4. For a cycling path, specify the virtual device IDs representing the associated pair of video
and audio probes.
5. For a manual path, specify the card IDs representing the associated pair of video and audio
probes, if present.
MANUAL PATHS
(PHYSICAL)
ACTUAL VIDEO
PROBE ID
Unique ID of a video probe, as specified on the Devices worksheet.
Case sensitive.
Mandatory in cycling paths. Optional in manual paths.
ACTUAL AUDIO
PROBE ID
Unique ID of an audio probe, as specified on the Devices worksheet.
Case sensitive.
Mandatory in cycling paths.
Optional in manual paths.
STREAMER ID Unique ID of the streaming device, as specified on the Devices worksheet.
Case sensitive.
Mandatory.
1. Rows you wish to leave empty must include the two asterisks in this column.
Note: In the case of HCP-1801 HD/SD video control probes with embedded audio,
both VIRTUAL VIDEO PROBE ID and VIRTUAL AUDIO PROBE ID should refer to the
same virtual device ID, and both ACTUAL VIDEO PROBE ID and ACTUAL AUDIO
PROBE ID should refer to the same physical card ID.
Table 3-4: Paths worksheet contents (
Conti nued
)
Area Column Description