Setup guide
Table Of Contents
- Introduction to iControl Edge
- System Requirements
- Installation and Setup
- Key Concepts
- Task 1: Preparing to Install an iControl Edge System
- Task 2: Installing the iControl Application Server
- Task 3: Preparing a PC for Configuring the Application Server
- Task 4: Configuring the Application Server
- Task 5: Installing & Configuring EdgeVision Devices
- Task 6: Installing & Configuring Densité Systems
- Task 7: Installing & Configuring GC-100 Network Adapters
- Task 8: Installing Set-Top Boxes
- Task 9: Installing & Configuring Allégro Systems
- Task 10: Verification & Readiness Check
- Task 11: Managing the iControl Edge Configuration Files
- Task 12: Uploading and Applying iControl Edge Configuration Files
- Key Concepts
- Troubleshooting
- Installing PuTTY
- Using WinSCP
- Contact Us!
Installation and Setup
Paths Worksheet
96
4. Identify the function associated with your DVR.
5. Take note of the name of the function.
The prefix is the function name without the
macros() ending. In this case, it is
Explorer3250HD.
Paths Worksheet
For a given location, the Paths worksheet specifies which set-top box feeds which Densité
modules (usually a pair of audio/video probes represented as virtual devices associated with
a common cycling profile; see "Devices Worksheet" , step 13), and whether an EdgeVision or
Allégro is used for streaming signals from a designated set-top box.