Operating instructions

GUIDE TO INSTALLATION AND OPERATION
28 | FRS-1801
the frame can use this feature. It has no effect unless you have selected Fast for the refresh rate. The actual
slot number of this card, as shown in the window title bar, will appear when the checkbox is ticked.
• This feature is only available with the version 1 of the Densité Controller
3.4.12 The RALM panel
The Remote Audio Level Meter (RALM) panel
displays audio level meters for up to 8 channels.
Channels are displayed in pairs, so up to four
meters will be present in the meter display window
The source for each meter is selected using the
pulldowns in the RALM Remote Control area at
the bottom of the control panel.
• Choices are OFF, Embedded CH 1&2, and
each pair up to CH 15&16, AES1 to AES 4
The meter is divided into three zones, and the
dividing points and color of each zone are
individually configurable under the Meter Ballistics
Config tab.
Speed – select the meter response from the pull-
down list, options are [ fast, medium, slow ]
RALM Connections tab
Use the radio buttons to turn the meter display ON
(RALM) or OFF for the indicated channels. The
meter appears directly above the controls.
Reset Counter: click this button to reset the overload counter on the ALM display to zero. See the next
section for instructions on setting up the overload counter.
Meter Ballistics Config tab
Type – select a type of meter from the pull-
down list
Upper Zone Limits – select the crossover
level between the upper and middle zones
of the meter (the range of values shown in
the pull-down list depends on the type of
meter selected)
Lower Zone Limits – select the crossover
level between the middle and lower zones of the meter (the range of values shown in the pull-down list
depends on the type of meter selected)
Color samples – the three samples show the current selected color for the upper, middle and lower zones of
the meter.
• Click on the color sample of a zone to open a color selection panel to choose a different color for that
zone
Figure 3.31 RALM group – Meter Ballistics Config tab
Figure 3.30 RALM panel – RALM Connections tab