Specifications
GUIDE TO INSTALLATION AND OPERATION
20 | RCP-100
RCP100.xxx> makeupdatedisk
RAM disk initialized - size is 5000 blocks...
Volume name is 3.0.0
Current directory set to 3.0/
RCP100.xxx>
Do not close the Telnet application.
Note: If the command makeupdatedisk is not recognized by RCP-100, type the following command,
which gives the same result: makeramdisk 5000
5. Start the WS_FTP application
6. Connect to RCP-100 using the following parameters:
• Host Name/Address: (RCP-100 IP address)
• Host type: Automatic detect
• User ID: Anonymous
• Password: guest
WARNING: Select the “BINARY” file transfer mode for steps 7 and 13!
Using another transfer mode could lead to an incorrect data transfer, and the RCP-100 will
no longer be able to work, or to be reprogrammed via Telnet. It will require factory
reprogramming.
7. In WS-FTP, copy the file rcp_update.bin located in the same directory , (left window of WS_FTP) to
RCP-100 (right window of WS_FTP). Use the Binary file transfer mode - see WARNING!
8. Disconnect WS_FTP from RCP-100 (click " Close " button)
9. Return to the Telnet application window and type: updatercp. On the telnet application window the
written flash sectors will be displayed gradually.
10. After the file is copied in the RCP-100 flash memory, type restart. RCR-100 will restart with the new
firmware.
In the following steps the * typ files will be loaded into the RCP-100 flash memory.
11. Restart the Telnet application telnet connect to RCP-100 with the IP address of RCP-100. Type
makeramdisk. The following message will be displayed:
RCP100.xxx> makeramdisk
RAM disk initialized - size is 2048 blocks...
Volume name is 3.0.0
Current directory set to 3.0/
RCP100.xxx>
12. In the Telnet window, type cp -r 45.0 3.0
13. In WS-FTP, copy all the files * typ of the new version, located in the same directory, (left window of
WS_FTP) to RCP-100 (right window of WS_FTP). Use the Binary file transfer mode - see WARNING!
14. Disconnect WS_FTP from RCP-100 (click the " Close " button)
15. In the Telnet application window, type copytoflash. The following message will be displayed: