Specifications

GUIDE TO INSTALLATION AND OPERATION
RCP-100 | 11
When the selected device (or the frame that holds the device) is not accessible, an error message is
displayed. The status LED is also cleared.
Cannot Reach Device: When a device is selected, an RCP in CLIENT mode will try to connect to the
service corresponding to this device, displaying CONNECTING...
CONNECTING...
DEV:DVP-101i
GROUP| DEV | |
If, after 10 seconds the connection is not established, the CANNOT REACH DEVICE error message will be
displayed:
CANNOT REACH DEVICE
DEV:DVP-101i
GROUP| DEV | |
If the RCP-100 is in Device Control mode and the selected device becomes inaccessible (device removed
from frame or not responding, or frame not accessible), the RCP-100 will automatically quit the Device
Control mode and return to the Device Selection mode.
.TYP File Not Found: A device is not supported by the RCP-100 if the menu configuration file for this device
is not found or cannot be read when trying to access the device. The error message is:
.TYP FILE NOT FOUND
DEV:DVP-101i
GROUP| DEV | |
Card Removed: After startup, the list of all found devices can be browsed and the desired device can be
selected. If a device is removed from a chassis, the name of this device will be displayed in reverse (white
characters on black background) in browse mode, signaling the absence of the card. If the card is inserted
into another slot, while the previous slot is left empty, restart the RCP-100 to remove the reference to the
removed card.
FRAME: SYMPH.10
SLOT:14.ASD-221i.20...
FRAME| SLOT | |
If the DEVICE button is pressed in an attempt to enter into the Device Control mode, the message CARD
REMOVED will be displayed for two seconds, as shown:
CARD REMOVED
SLOT:14.ASD-221i.20...
FRAME| SLOT | |
If the same card is put back into the same slot, the display will be refreshed and the name of the card will be
displayed in Normal (i.e. non-reversed) mode. Device Control mode is once again accessible for this card.
If another type of card is inserted into the slot, the new card name will be displayed in Normal mode.