User manual

Revision: 0 5
Technical specifications are subject to be changed without notice
1.2. Connection drawing
Configuration switch
Video input section Video output section
RS-232 port MIDI bus Power connector
Vertical interval trigger
2. Power connection
Do not connect mains to the desk top power supply before connecting the power supply to the router.
Connect the DB9 female connector from the desktop power supply to the main unit. Tighten the screws to assure a proper
contact. To connect mains to the desk top power supply you need a mains cord with IEC 320 connector. NTW-VD3232 uses
the desk top power model
AC-10-87-30-005 (±5V / 30W)
.
If an external power supply is used the NTW-VD3232 router requires +5V DC with a minimum current of 4100mA. The
following pin-out is used on the DB9 male power connector:
Pin 1 and 9 0V
Pin 2 and 5 +5V
3. Connecting the NTW-VD3232 to your PC
For connection to a PC with Miranda’s i-Control control software the RS-232 interface is used. The
RS-232 port on all Network devices uses the standard DCE pin-out, see pin-out table under 4.3.
A standard modem cable can be used for connecting the router to the PCs serial port. The RS-232 interface for all Network
32x32 routers works with a baud rate of 19200.
3.1. Selection of router address
The router address depends on the system configuration the router is going to work with. See chapter 5 for more information.
All routers are delivered with default address 0. A router addressed to 0 can be controlled from the i-Control software with
address 0. i-Control offers the control of up to 16 different routers or combinations of routers.
3.2. Pin-out of RS-232 connector
The DB9 female connector for the RS-232 port has the following pin-out:
Pin 2 Tx
Pin 3 Rx
Pin 5 GND