Installation guide

Intuition XG Installation & Quick Start Guide 3-7
Installation instructions for the Intuition XG-3U/Dual
4. Align the larger end of each hole against its corresponding button. Once all aligned,
push the holes toward their corresponding buttons and the rail is placed on the chassis.
5. Once the rail is placed on the chassis, pull the rail forward until the rail buttons lock in
the small ends of the corresponding holes.
6. Secure the rail to the chassis with a Type G screw. Repeat the above steps 2 to 6 to
install the other rail on the other side of the chassis.
7. After you have installed the inner rails on the chassis, you are ready to install the outer
rails of the rail assemblies to the rack.
In the package, locate a pair of front (-short) and rear (-long) brackets. Please note that
the brackets are marked with Up/Front arrows (-front) and Up/Rear arrows (-rear).
8. Secure the front (-short) bracket (marked with the Up/Front arrows) to the outer rail with
two Type G screws.
9. Locate the two buttons on the outer rail and attach the rear (-long) bracket to it by
sliding the opening of the rear rail through the button.
10. Measure the depth of your rack and adjust the length of the rails accordingly.
11. Repeat the same steps to install the outer rail on the chassis.
12. Secure both outer rail assemblies to the rack with Type H screws and Type I washers.