Installation guide
3-6 Intuition XG Installation & Quick Start Guide
Installation instructions for the Intuition XG-3U/Dual
Mounting the Intuition XG-3U/Dual chassis in a rack
Included in the shipping package is a Rack mounting kit, which contains the rails, screws
and washers required to mount the Intuition XG chassis into an equipment rack. Note that
the rails are designed to fit in racks with a depth of 28” to 33”.
The following instructions provide step-by-step instructions for installing the rails and
mounting the Intuition XG chassis into an equipment rack.
To install chassis rails:
1. Remove the Intuition XG faceplate by pulling the faceplate’s handles away from the chassis.
2. Included in the shipping package are a pair of rail assemblies. In each rail assembly,
locate the inner rail and outer rail.
Press the locking tab to release the inner rail from its locking position and pull out the
inner rail from the rail assembly. (The inner rails are to be attached to the chassis and
the outer rails are to be installed in the rack).
3. Locate the five rail buttons on each side of the chassis and locate the five
corresponding holes on each of the inner rails.
(*Please note that one end of the hole is larger than the other end of the hole.)
Pull out the inner rail
(to be attached on the chassis)
Press the Locking tab
Outer rail (to be installed in the rack)