Operating instructions

Intuition XG Installation & Quick Start Guide 4-1
4 QUICK START INSTRUCTIONS
This chapter provides you with instructions for performing the initial setup tasks to get the a
newly installed Intuition XG device up and running. The procedure concludes by verifying
the installation by previewing the playout of an asset in Intuition XG’s Live Window and a
broadcast monitor.
The following table summarizes the tasks that you must perform to quickly start up a factory-
configured Intuition XG device.
Step # Task description
1
Start up the Intuition XG device (page 4-2)
• Plug the DVI monitor’s power cable into a power socket and power it on
• Plug the Intuition XG’s power supply cable(s) into a power socket
• Power on the Intuition XG unit
2 Assign a new IP Address for the Intuition XG device (page 4-4
)
3
Verify the installation by previewing the playout of an asset (page 4-5
)
• Verify the Intuition XG’s Output Resolution setting
• Enable the Intuition XG’s Live Window
• In Xplay, add an asset to a playlist and verify that it plays out properly
• On a dual channel Intuition XG, repeat the above steps for channel B
4
Complete the quick start procedure (page 4-8
)
• Disable the Intuition XG’s Live Windows
• Disconnect the keyboard, mouse and DVI monitor