Operating instructions

Kaleido-X16
Quick Start Guide
29
Two LEDs are visible on the front panel, one for each power supply. When lit, they both indicate the
same status:
When the ABT is powered up, all three LEDs will be orange until the boot sequence is terminated. This
is a visual indicator that the LEDs are functioning properly.
RS-422 Connection Diagram
The Kaleido-X16 supports two RS-422 ports over RJ-45 connectors. These ports allow the Kaleido-X16 to
connect to external serial devices such as a router, production switcher, or router controller.
Color Board Status
Off No link detected
Green Normal (good link)
Orange Activity
Red Hardware fault
Flashing red Upgrading firmware
Color Board Status
Green Normal
Flashing green Normal, rebooting
Orange Warning
Flashing orange Warning, rebooting
Red Hardware fault
Flashing red Upgrading firmware
Note: The Kaleido-X16’s two RS-422 ports each have an RJ-45 connector in order to preserve
space on a busy panel. The RS-422 interface specifies a DE-9S connector, so if you are using this
interface, you will require a DE-9S-to-RJ-45 adapter cable. Miranda supplies such a cable,
correctly wired for this application (Miranda part no. 1737-3000-102).