Operating instructions

20
Setting Up the Kaleido-X16
Configuring an Audio Bridge Terminal
2
To configure the IP address and other network settings of the ABT, do the following:
1. Connect a PC to a switch.
2. Referring to “Configuring a Client PC” on page 13, configure the PC with the following network
settings:
3. Apply power to the Audio Bridge Terminal and make sure it is connected to the same switch as the PC.
If the switch is Power over Ethernet (PoE) enabled, simply connect it to the unit using an Ethernet
cable. If not, PoE mid-span (inserter) equipment must be placed between the switch and the Audio
Bridge Terminal.
4. Press the RESET button (located on the right-hand side of the ABT rear panel beside the ETHERNET/
POWER RJ-45 connector) for at least 1 second. The Audio Bridge Terminal will reboot with the
following static network configuration:
5. Using a web browser on the PC, connect to the ABT using the following address: 10.0.3.190.
The home page of the ABT’s built-in web server is displayed.
6. Click Network Configuration (in the navigation pane).
The Network Configuration page is displayed.
DHCP Off
Static IP address 10.0.0.1
Subnet mask 255.255.0.0
Default gateway 10.0.0.1
DHCP OFF
Static IP address 10.0.3.190
Subnet mask 255.255.0.0
Default gateway 10.0.0.1