Operating instructions

Setting Up the Kaleido-X16

Setting up the Kaleido-X16 Hardware

To set up the Kaleido-X16 hardware, do the following:

1. Make the required network and other connections to your Kaleido-X16. Connect a client PC, the

Kaleido-RCP2 (if available), and an Audio Bridge Terminal to a dedicated 100Base-T Ethernet switch.

You can also connect a mouse and a keyboard to your Kaleido-RCP2.

2. The Kaleido-X16 has been configured with an automatically detected resolution or, if the required

information is not available, with a fall-back resolution of 1280 x 1024 @ 60 Hz. Connect the output of

the Kaleido-X16 to one or more displays that support this resolution.

3. Connect one or more video sources to the frame.

4. Change the resolution from the monitor wall by performing the following steps:

a ) Connect a mouse to one of the USB connectors of the Kaleido-X16.

b ) Right-click anywhere on the monitor wall, point to Monitor Wall, then click Display resolution:

The Display Resolution window appears:

Note: The Audio Bridge Terminals (ABTs) and Kaleido-RCP2 are optional devices, and may not

have been shipped with your Kaleido-X16 system. For information on these and other

Kaleido-X16 options, please contact your nearest Technical Support center. See “Contact Us!” on

page 75.

IMPORTANT: At initial startup, after your system has auto-detected the resolution of the display, it is

strongly recommended that you manually set the output resolution and clear the Use

detected monitor resolution checkbox.