Operating instructions

12
Setting Up Your Multiviewer
Networking Setup
If your system was configured prior to shipment, then a layout will appear on all
displays. Otherwise, a gray screen will appear with the following message in the
middle: “No layout has been assigned to this room. Please load a layout.”
Loading a Layout
To load a layout on the monitor wall
1 Connect a mouse to the Kaleido-RCP2 (if available) and log on to the Kaleido-X16 from
the Kaleido-RCP2, if you have not already done so (see
Using the Kaleido-RCP2 with
Default Settings, on page 10).
Alternatively, connect the mouse directly to one of the USB ports on the Kaleido-X16
frame.
2 Right-click anywhere on the monitor wall, point to Monitor wall (if you clicked a
monitor), and then click Load layout on the shortcut menu.
Monitor wall shortcut menu
A layout browser appears on the displays associated with the current room.
3 Select the layout you wish to load from the list of available layouts for this room, and
then click OK.
The selected layout appears on the room displays.
Configuring a Client PC
The client PC that you will use to communicate with the Kaleido-X16 multiviewer (via
XAdmin and XEdit) and the multiviewer itself must have IP addresses within the same
subnet. The following procedure applies to a typical Windows
7 or Windows 8 system. For
Windows
XP, see Changing an IP Address on Windows XP, on page 14.
Changing an IP Address on Windows 7 or Windows 8
To change the IP address of a client PC that has Windows 7 or Windows 8
1 Press the Windows key on your keyboard, type “control panel” and then press Enter.
2 In the search box, type “adapter”, and then, under Network and Sharing Center, click
View network connections.
Note: To access other layouts, press the LOAD button. To assign a layout to
a preset button, press and hold the button for more than six seconds while
the desired layout is showing on the monitor wall.