Installation manual

34
Peripheral Equipment
Enabling or Disabling DHCP
2
Enabling or Disabling DHCP
The following table shows how to enable or disable the automatic allocation of an IP address from a server.
This option is commonly called DHCP (the protocol that is used for address allocation). In our example, we
suppose that the DHCP option is enabled, and must be disabled. This task is performed by using the
Configuration menu.
Action LCD indication Other buttons
Press and hold the ENTER key
for at least 8 seconds to enter
the Configuration menu.
At the end of the 8 seconds:
Configuration
ROOM SELECTION
Digit keys 2 (UP) and 8 (DOWN), and the ENTER and ESC
buttons, are lit; other digit keys are dimmed.
Press ENTER again to obtain
the list of rooms from all
Kaleido systems currently
available on the network.
For some time until the list is
received:
Acquiring room list...
Once the room list is received:
ROOM Select
RMA
Press the 8 key twice, until the
room you wish to select (i.e.
RMC) appears on the display.
(Press
2 to scroll in the
opposite direction.)
ROOM Select
RMC
Once the display shows the
desired room name, you can:
• press ENTER to select this
room;
• press ESC to cancel the
selection and return to the
previous menu level in the
menu.
Configuration
ROOM SELECTION
Digit keys
2 (UP) and 8 (DOWN), and the ENTER and ESC
buttons, are lit; other digit keys are dimmed.
Press ESC to exit the
Configuration menu.
RMC All buttons are dimmed.