Installation manual

Kaleido-X16 Installation

GPI I/O

You should ensure your GPI physical connections are well established. In the following example, the goal

is to trigger a relay and light up a light.

To facilitate cabling of the GPI inputs and outputs, a terminal block adapter is available separately (Miranda

part number KXA-TBA-44). The GPI Terminal Block Adapter accommodates up to 44 terminal block

connections using positive and negative terminal connections. Each column on the terminal block has

6 positive and 6 negative terminal connections that correspond to each pin position. Negative pins

(labelled with an N) on the Terminal Block Adapter are not used as connections. Positive pins (labelled with

a P) and Ground pins (labelled with a GND) correspond to GPI-IN connections:

CAUTION: In the example, below, make sure your P and N connections are in the proper polarity

otherwise your GPI output will always be in the ON state.