User`s manual

78
Creating Layouts
3
8. Click on the Properties Panel.
9. Select the corresponding Output under Connection|RS-422 Com Port
Interconnection Output selection
10. Click File|Save or the Save tab in the XEdit application toolbar.
Configuring Internal Router Control
Note: This configuration is required to make your internal router appears as a Probel switcher (SW-P-O8
protocol) from a third party point of view. This step allow the configuration of the matrix, frame ID and also
allows you to label inputs and outputs with consecutive numbering.
To configure Internal Router Control:
1. Repeat Step 1 from Configuring a System instruction set.
2. Click on Internal Router Mapping.
The Internal Router Mapping central panel appears.
Kaleido-X User's Manual.book Page 78 Friday, August 24, 2007 4:39 PM