User`s manual

60
Creating Layouts
3
Overview
In this section, you learn:
• “To create a system:” on page 68
• “To configure a system:” on page 70
• “To obtain Kaleido-X FR4 factories:” on page 72
• “To use a serial port test 3rd party device:” on page 73
• “To configure calibration:” on page 74
• “To calibrate a KXI-16HSV audio source:” on page 75
• “To calibrate an ABT audio source:” on page 76
• “To calibrate router field selection switching:” on page 77
• “To calibrate reclocking:” on page 78
• “To configure alarm threshold:” on page 79
• “To configure alarm debouncing:” on page 80
• “To configure the network router panel integration:” on page 80
• “To configure Internal Router Control:” on page 82
In this section, you will be able to answer the following questions:
• “What is calibration and when is it used?” on page 65
• “What is a system?” on page 65
• “What cards are supported by XEdit?” on page 66
• “What is a third party device?” on page 66
• “What are physical assignments?” on page 66
Checklist
XEdit User Guide Task List
Follow these steps to complete all the tasks required to get started using XEdit:
Kaleido-X User's Manual.book Page 60 Friday, August 24, 2007 4:39 PM