User`s manual

44
Operation of the Monitor Wall
2
The GPI state changes.
Note: GPI Lines configured as Outputs can have their state set manually for test purposes in the System tab
of XEdit using the Calibration filter.
Obtaining IP Addresses and System Names
To Obtain an IP Address and System Name:
1. Move the Kaleido-X Cursor to the bottom right corner of any display.
After two seconds, the Monitor Wall Dashboard appear.
Monitor Wall Dashboard
Note: The dashboard contains: System name, Frame IP address and the software version.
Triggering Audio Monitoring using the RCP2
To Trigger audio monitoring using the RCP2:
1. Move the mouse cursor above a specific monitor and press Audio Monitoring on the RCP2.
This shall select the first Audio Level inside the channel that the monitor is assigned to. Alternatively,
the user can choose to monitor a specific Audio Level. This can be achieved by the following step.
2. Move the mouse cursor above a specific Audio meter inside a specific Monitor and then press Audio
Monitoring on the RCP2.
Triggering Audio Monitoring using an Action
To Trigger audio monitoring using an action:
1. Select an audio source to monitor by using an Audio Monitor action.
This action can be assigned to a widget on the Monitor wall and then triggered as any other action.
Kaleido-X User's Manual.book Page 44 Friday, August 24, 2007 4:39 PM