User`s manual

23
To verify that the ABT is functioning normally, do the following:
1. Inspect the ACTIVITY and front panel LEDs on the unit to make sure there are no error conditions.
The ACTIVITY indicator is located on the right-hand side of the rear panel. This LED reports the status
of the ethernet connection as follows:
Two LEDs are visible on the front panel, one for each power supply. When lit, they both indicate the
same status:
When the ABT is powered up, all three LEDs will be orange until the boot sequence is terminated. This
is a visual indicator that the LEDs are functioning properly.
Color Board Status
Off No link detected
Green Normal (good link)
Orange Activity
Red Hardware fault
Flashing Red Upgrading firmware
Color Board Status
Green Normal
Flashing Green Normal, rebooting
Orange Warning
Flashing Orange Warning, rebooting
Red Hardware fault
Flashing Red Upgrading firmware
Kaleido-X User's Manual.book Page 23 Friday, August 24, 2007 4:39 PM