User`s manual

Ethernet cable. If not, PoE mid-span ("inserter") equipment must be placed between the hub or switch

and the Audio Bridge Terminal.

4. Press the RESET button (located on the right-hand side of the ABT rear panel beside the ETHERNET/

POWER RJ-45 connector) for at least 1 second. The Audio Bridge Terminal will reboot with the

following static network configuration:

DHCP = OFF

Static IP address = 10.0.3.190

Subnet mask = 255.255.0.0

Default gateway = 10.0.0.1

5. Using a web browser on the PC, connect to the ABT using the following address: 10.0.3.190.

The home page of the ABT’s built in web server is displayed.

6. Click on Network Configuration (in the left panel).

The Network Configuration page is displayed.

7. Change the ABT’s network settings, as necessary, then click Apply & Reboot.

For more information, please refer to the Audio Bridge Terminal User’s Manual, available on the CD-ROM

that shipped with your system.

Kaleido-X User's Manual.book Page 17 Friday, August 24, 2007 4:39 PM