User`s manual

Overview

6. Select the NETWORK MASK menu using the “2” key (to move up in the list) and/or the “8” key (to move

down the list), then press ENTER.

7. Using the numeric keypad, type the chosen network mask, then press ENTER.

You have successfully configured a static IP address on the RCP2.

To select a ROOM for the RCP2, do the following:

1. Press and hold the ENTER key for “8” seconds to enter the Configuration menu.

2. In the ROOM SELECTION display, press ENTER again to get the room list from the Kaleido-X systems that

are currently available on the network.

3. With the room list displayed, highlight the room you wish to access by pressing the “2” key (to move

up in the list) and/or the 8 key (to move down the list).

Note: By default, the two head (DVI/VGA) outputs from each of cards OUTPUT A, B, C and D are assigned

to ROOM 1, ROOM 2, ROOM 3 and ROOM 4 respectively.

4. When the desired room name is highlighted, press ENTER to accept the new selection.

5. When prompted, log in to the selected ROOM (see “RCP2 Login” on page 13).

Kaleido-X User's Manual.book Page 14 Friday, August 24, 2007 4:39 PM