User`s manual

Detailed Directions

Step 1 – Physical Setup

To set up the Kaleido-X hardware, do the following:

1. With the Kaleido-X frame (enclosure) installed in its designated rack position, and before powering up

the unit, verify that each card is securely seated in its slot.

2. Make the network and other connections as shown in the diagram on the next page. Connect a Client

PC, the Kaleido-RCP2, Audio Bridge Terminal(s), and every output module to a dedicated 100Base-T

Ethernet switch. You can also connect a mouse and a keyboard to your Kaleido-RCP2.

Note: The Kaleido-RCP2 Remote Control Panel and Audio Bridge Terminals (ABTs) are optional devices,

and may not have been shipped with your Kaleido-X system. For information on these and other

Kaleido-X options, please contact your nearest Technical Support center.

3. The Kaleido-X has been tested and configured with a default resolution of 1280 x 1024 at 60 Hz.

Connect the output of the Kaleido-X to one or more displays that support this resolution.

4. Connect one or more video sources to the frame.

Kaleido-X User's Manual.book Page 5 Friday, August 24, 2007 4:39 PM