User`s manual

165
X indicates the AES. Valid value can be either 1 or 2.
• setKAudioOut
• The user can select the audio to be monitored by using this Gateway command. The syntax of the
command will differ if the user indicates to monitor audio coming from a stream (Note - streaming
sources are not supported by Kaleido Alto/Quad), from an audio card, from an embedded source or no
audio at all. In general, you can select any audio source to be monitored, even if this source is not
represented in an audiometer on the current layout.
<setKAudioOut>DETAILS</setKAudioOut>
DETAILS will differ depending on the type of audio source being selected for monitoring, as shown below.
Gateway response:
• <ack/>The command was correctly interpreted.
• <nack/>The command was not executed, due to bad spelling or invalid parameter.
DETAILS:
To select a STREAMING source (Kaleido-K2 only), format the command as follows:
• <setKAudioOut>set Type="STREAMING" IP="999.999.999.999" FeedID="XX"</setKAudioOut>
Where:
999.999.999.999 is the IP of the machine from where the stream occurs.
XX is the identifier of the feed to use.
To select an AUDIO CARD source, format the command as follows:
• <setKAudioOut>set Type="AUDIOCARD" Input="999"</setKAudioOut>
Where:
• 999 indicates the input from the card.
To select an EMBEDDED source, format the command as follows:
• <setKAudioOut>set Type="EMBEDDED" Input="AAA" Group="BB" AES="X"</setKAudioOut>
Where:
• AAA indicates the video input.
• BB indicates the group. Valid values range from 1 to 4.
• X indicates the AES. Valid value can be either 1 or 2.
To STOP audio monitoring and MUTE the audio output:
Kaleido-X User's Manual.book Page 165 Friday, August 24, 2007 4:39 PM