User`s manual

159
Document Conventions
Each command in this document is presented in the following format:
"The Command name” Kaleido types it applies to.
Command description.
The proper command syntax with variables.
Gateway Response - a list of possible answers:
• For a successful execution of the command
• For an unsuccessful execution of the command
Special notes for the command or specific platform.
Gateway Command Descriptions
Please note that the syntax must be exactly replicated when sending a command.
openID
This command opens a session with the specified Kaleido.
Please note that it is not necessary to open a session every time you want to send a command to the
Gateway. Since opening a session takes a few seconds, it is recommended that you keep a session open as
long as commands need to be sent.
<openID>IP_ADDRESS_0_4_0_0</openID>
On the Kaleido-X:
To open a session without room context:
• setKCurrentLayout • Loads a specific Layout. • 147
• getKLayoutList • Gets the list of available Layouts. • 148
• setKStatusMessage • Sets a Gateway Alarm to the specified
state.
• 148
• setKChannel • Associates a Channel to the specified
Monitor.
• 149
• setKDynamicText • Configures the text to display for a
Dynamic Text.
• 149
• getKAudioOut • Gets the identity of the current audio
output
• 150
• setKAudioOut • Selects the audio to be monitored • 151
• Command • Description • Page
Kaleido-X User's Manual.book Page 159 Friday, August 24, 2007 4:39 PM