Operating instructions

GUIDE TO INSTALLATION AND OPERATION
18 | IRD-3802
Insertion Line: The Insertion line is used to select on which line in the VANC the AFD packet (SMPTE 2016)
will be inserted. It is not necessary to specify the detection line since the card will automatically detect the
incoming packet.
Default settings
The Default data box shows the default AFD code to be used if no valid
AFD code is detected at the input (AUTO), or the AFD that is always
used (MANUAL)
Change: Click the Change… button to open the Select AFD panel
showing the available AFD codes that could be used as the default.
Click on one to select it, then click Apply or OK at the bottom of the
panel.
Flags
This section gives information about AFD flag management.
Presence – the status icon is green if AFD flags are detected in the
input data stream
Detected – the data box shows the AFD code for the detected flags
Inserted – the data box shows the code of the AFD inserted in the
output data stream
Aspect Ratio Scaling Mode
Use the pulldown to select the aspect ratio scaling mode that will be
used. These options are available:
OFF
Auto
Stretch
Center Cut
Letter box
Pillar box
Figure 3.6 Select AFD window