User manual

Automation Protocol Video Commands
Miranda Technologies Ltd Page 72
Fade-To-Black State Tally Yf
The Y6 command (page 63) enables or disables unsolicited video tallies for
the serial/network port on which the command was received. This includes
the Yf tally which returns keyer Fade-to-Black position information for each
layer as state changes (unsolicited).
CMD Param_1 Param_2
Yf %1x Layer No. %1x Fade-to-Black Position
Possible values for Keyer Fade-to-Black Position are:
FTB_ON 0
FTB_OFF 1
FTB_INBETWEEN 2
Text Crawl Count Tally Yg
Note: This command is only enabled if either the video tallies are
enabled (Y61) or the device is set to operate in passive mode
[Ya1].
This tally is sent by Imagestore Intuition every time a text crawl completes
for text that been setup to send this tally had cycled. The Yg command is
enabled using the Y6 or the Ya command. This command enables or disables
the text crawl count tally and is used in conjunction with the Zh command.
For a tally to be issued for any object, the ‘Tally’ checkbox should be set
within Intuition Builder.
For Imagestore Intuition this will return the following tally every time that a
text crawl completes:
CMD Param_1 Param_2 Param_3 Param_4
Yg %1x
Layer No.
%02x
Box No.
%1x
Final Crawl Flag
%04x
Crawl Count
The final crawl flag is 0x1 if the crawl just completed was the final one.