User manual

Automation Protocol Video Commands
Miranda Technologies Ltd Page 68
Possible values for the Voice Over positions are:
VOICE_OVER_OFF 0
VOICE_OVER_ON 1
VOICE_OVER_INBETWEEN 2
Note: For Imagestore 2, parameters 3 and 4 are “Voice Over 1 Pair 1”
and “Voice Over 1 Pair 2” respectively.
The status of the Y8 tallies can also be enquired using:
CMD
Y8
This will return:
CMD Param_1
Y8 %x
1=Enabled, 0=Disabled
Image Load Tallies Y9
The Y6 command (page 63) enables or disables unsolicited video tallies for
the serial/network port on which the command was received. One of these
video tallies is the Image Load Tally (Y9) which returns the filename of the
image file that is currently loaded into a layer – via R0 (page 87)
Cmd Param_1 Param_2
Y9 %1x Layer No. %s Image File Name
As video tallies are enabled the Imagestore sends out Y9 tallies in bulk (one
for each layer) to enumerate all of the currently loaded images. Subsequent
changes to loaded images (via R0 or A commands) are then tallied on an
individual basis.
Note: When a layer is unloaded the Image File Name will be equal to
“> Empty <”.