User manual

Automation Protocol Video Commands
Miranda Technologies Ltd Page 66
The information returned for the Imagestore 2/3, Imagestore 300[+],
Imagestore HD-TV and Imagestore 750 is:
CMD Param_1
Y6 %1x: Tally Enable
1=Enabled, 0=Disabled
The information returned for the LGK-3901 and DSK-3901 is:
CMD Param_1 Param_2
Y6 %1x: Tally Enable
1=Enabled, 0=Disabled
%1x: Intuition Tally Forward Enable
1=Enabled, 0=Disabled
Request Wake-up Packet Y7
This command causes an unsolicited wake-up packet to be returned by an
Imagestore.
CMD
Y7
Wake-up Packet Y7
The following unsolicited packet is sent by Imagestore on unit restart or on a
request using above command. This allows the listening device know when
an Imagestore has been restarted so that volatile settings (such as video/audio
tallies and metering) can be reset. The packet also provides information about
IP Address and serial number of the unit.
CMD Param_1 Param_2
Y7 %04x Machine Serial Number %08x Machine IP Address
Note: The Y7 command is normally only used by Presmaster.