User manual

Automation Protocol Scheduled Commands
Miranda Technologies Ltd Page 253
IntuitionXG Commands
Note: The following commands only apply to the IntuitionXG. Note
that a space separates the command and the first parameter.
The “|” character is use to separate each parameter from the
next parameter in the command.
Cue V0
This sets a template to be cued onto a IntuitionXG keyer, which can be
identified using the keyer number, or the keyer name that is used in Xplay.
CMD Param_1 Param_2 Param_3
V0 %s
Keyer Number or
Keyer Name in
Xplay
|%x
Template ID Type
0 – Recall ID
1 – Name
2 – Embedded Page
|%s
Template ID
If the template ID is specified as ‘Name’, the name used as Param_3 can be
specified as the name of the page, template, panel or scene itself without any
category information (the ‘short’ name), or it can be specified as a fully
qualified name. Note that since ':' is a reserved character, a fully qualified
name would have to be written using escaped characters.
Example:
To cue keyer ‘1’ with an page "XMS:Pages.Demo:PG_Lower3rd":
V0 1|1|XMS\3APages.Demo\3APG_Lower3rd
If the template ID is specified 'Embedded Page', the embedded page xml
must be specified. This will contain characters that need to be escaped.
Take V1
This causes items cued on IntuitionXG keyers to be taken. The keyers can be
identified using the keyer number, or the keyer name used in Xplay. Multiple
keyers are separated by the ‘,’ character and can be taken using one
command.