User manual

Automation Protocol Passive Mode Commands
Miranda Technologies Ltd Page 248
Layer Rate Yc
This tally is issued by the Imagestore 2/3 in passive mode whenever one of
the layer fade or fade-to-black rates changes on the Imagestore. The format
of the Imagestore 2/3 tally is as follows:
CMD Param_1 Param_2 Param_3 Param_4
Yc %03x
Midground
rate
%03x
Foreground
rate
%03x
Midground
FTB rate
%03x
Foreground
FTB rate
Strap Loop Count Yd
This tally is issued by the Imagestore 2/3 in passive mode whenever one of
the strap loop counts increments on the Imagestore. The format of the
Imagestore 2/3 tally is as follows:
CMD Param_1 Param_2
Yd %08x
Midground
loop count
%08x
Foreground
loop count
Enquire Passive Mode Ye
This command allows a remote device to check if Passive mode is on or off.
CMD
Ye
The response is:
‘Ye00’ if Passive mode is currently off
‘Ye01’ if Passive mode is currently on