User manual

Automation Protocol EAS Commands
Miranda Technologies Ltd Page 246
The text "This is an EAS crawl" is saved to the EAS crawl file specified by
the current priority. The next time that the EAS On (n1) command is
received, this text will be displayed.
Note: After using the ‘n3’ command, it is recommended to wait for
three (3) seconds before issuing the EAS On (n1) command. This
is to allow the Imagestore to store the text that has been set.
EAS Set Priority n4
This command is used to set the priority of the next EAS crawl, which will be
displayed on air.
CMD Param_1
n4 %02d
Priority
Examples:
n401 // Sets to the highest priority (1)
n402 // Sets to the medium priority (2)
n403 // Sets to the lowest priority (3)
Note: After using the ‘n4’ command, it is recommended to wait 3
seconds before issuing the EAS On (n1) command. This is to
allow the Imagestore to store the priority that has been set.