User manual

Automation Protocol MPEG Commands
Miranda Technologies Ltd Page 243
MPEG Commands
Note: The following commands only apply to the Imagestore 3 with
the MPEG hardware decoder option.
MPEG Control v0
The v0 command is used to control the MPEG Play-out card in Imagestore 3.
CMD Param_1
v0 %02x
Where:
CMD Description
v000
Stop MPEG Clip
v001
Play MPEG Clip
v002
Pause MPEG Clip
v003
Rewind MPEG Clip
v004
Next MPEG Clip
v005
Previous MPEG Clip
v006
Go to position HH MM SS FF
(Hours minutes seconds frames with spaces)
MPEG Load v1
This command loads a MPEG file WITHOUT invoking a keyer.
CMD Param_1
V1 %s
Filename
This command plays the relevant MPEG clip which then appears on the SDI
output of the IS3 without affecting what else is loaded into the keyers, in this
way IS3 could be configured as a clip server.