User manual

Automation Protocol Easytext Commands
Miranda Technologies Ltd Page 232
Stop Animation Zf
On Intuition units, animations occupy a template box rather than a full layer.
The Zf command behaves exactly as the S1 command except that it includes
a box number.
CMD Param_1 Param_2 Param_3
Zf %01x
Layer No.
%02x
Text Box
No.
%01x
Complete Cycle Flag
0 = Complete cycle
1 = Stop immediately
2 = Complete cycle and restart (in-loop-
out animations only)
Pause/Restart Animation Zg
This command is used to pause or restart a roll or crawl. A value of 1 pauses
the roll/crawl, and 0 will restart it. The box is addressed by layer on
Imagestores as follows:
CMD Param_1 Param_2
Zg %01x
Layer No.
%01x
Pause = 1, Restart = 0
Imagestore Intuition requires an extra parameter “Box number” because there
can be more than one crawl loaded into each layer
CMD Param_1 Param_2 Param_3
Zg %01x
Layer No.
%02x
Box No.
%01x
Pause = 1, Restart = 0
Set Text Crawl Count Zh
This command allows the user to specify the text crawl count for a box on a
layer, thereby overriding the default ‘Loop Count’ value that is set within the
Intuition template file (or overriding ‘Continuous’ looping). The contents of
the Intuition template file will not be updated as a result of the Zh command.