User manual

Automation Protocol Easytext Commands
Miranda Technologies Ltd Page 209
Set Program Low Pass Filter Enable oM
This command sets the program Low Pass Filter (LPF) enable for the main
input channels of the Dolby Digital encoder:
CMD Param_1 Param_2 Param_3 Param_4
oM %1x:
Bank No.
%1x:
Program
No.
%02x:
Flags
00
%1: LPF Enable
0 – Disabled
1 – Enabled
The current program LPF enable can be enquired using:
CMD
Param_1 Param_2
oM %1x: Bank
No.
%1x:
Program No.
The response is in the form of the set command.
Set Program LFE LPF Enable oN
This command sets the program Low Frequency Effects (LFE) Low Pass
Filter (LPF) enable for the LFE channel input of the Dolby Digital encoder:
CMD Param_1 Param_2 Param_3 Param_4
oN %1x:
Bank No.
%1x:
Program
No.
%02x:
Flags
00
%1: LFE LPF Enable
0 – Disabled
1 – Enabled
The current program LFE LPF enable can be enquired using:
CMD Param_1 Param_2
oN %1x: Bank
No.
%1x:
Program No.
The response is in the form of the set command.