User manual

Automation Protocol Easytext Commands
Miranda Technologies Ltd Page 201
The current program Dolby surround mode can be enquired using:
CMD Param_1 Param_2
o6 %1x: Bank
No.
%1x:
Program No.
The response is in the form of the set command.
Set Program LFE Enable o7
This command sets the program Low Frequency Effects (LFE) enable:
CMD Param_1 Param_2 Param_3 Param_4
o7 %1x:
Bank No.
%1x:
Program
No.
%02x:
Flags
00
%1: LFE Enable
0 – Disabled
1 – Enabled
The current program LFE enable can be enquired using:
CMD Param_1 Param_2
o7 %1x: Bank
No.
%1x:
Program No.
The response is in the form of the set command.
Set Program Dialogue Normalisation o8
This command sets the program dialogue normalisation value in order to
compensate for dialogue of different volumes. The normalisation value is the
mean level for the dialogue in a program relative to 0dB full-scale digital
level:
CMD Param_1 Param_2 Param_3 Param_4
o8 %1x:
Bank No.
%1x:
Program
No.
%02x:
Flags
00
%02: Dialogue Normalisation
(0 to 31)
The current program dialogue normalisation can be enquired using: