User manual

Automation Protocol Easytext Commands
Miranda Technologies Ltd Page 197
Metadata Commands
Note: The metadata commands are applicable to Imagestore 750 v2.0
or above. See the Imagestore 750 user manual for more
information.
Note that these commands have a “Flags” parameter that are not yet used and
are reserved for future use. The value “0” is currently to be used for this
parameter for all commands.
Set Pitch Shift Code o0
This command sets the pitch shift code, to indicate the amount of pitch shift
between the original and current playback speeds of the audio frame. See the
Dolby documentation for how to calculate the pitch shift code.
CMD Param_1 Param_2 Param_3
o0 %1x: Bank
No.
%1=02x: Flags
00
%08x: Pitch shift code
0 – No pitch shift)
(0x-800 to 0x07FF)
The current up-mix mode can be enquired using:
CMD Param_1
q0 %1x: Bank
No.
The response is in the form of the set command.
Set Program Description o1
This command sets the description of a program using any ASCII characters
between 0x20 and 0x7E. This command is not applicable to user metadata.
CMD Param_1 Param_2 Param_3 Param_4
o1 %1x: Bank
No.
%1x:
Program
No.
%02x:
Flags
00
%s: Program Description