User manual

Automation Protocol Audio Metering Commands
Miranda Technologies Ltd Page 193
Audio Metering Commands
Set Audio Metering Mode Y0
Specify audio metering mode, and specifies which mixes are to be metered.
On start-up, metering defaults to off. Once metering is enabled, the audio
Metering packets described below are sent on a regular basis.
Metering of up to 4 pairs is supported, with each pair being selectable
individually.
The ‘pairs to meter’ parameter is currently ignored, and Output pairs 1 to 4
are always transmitted –assuming the metering mode is not off.
CMD Param_1 Param_2
Y0 %1x: Metering Mode %04x: Pairs to meter – currently ignored.
Example:
void MeterInputs()
{
// Enable metering on all 4 pairs at
// half frame rate.
remote_send("Y011234");
}
The metering mode specifies the rate at which metering packets will be sent
Metering Modes:
Off 0
Meter at half frame rate 1
Meter at frame rate 2