User manual

Automation Protocol Audio Commands
Miranda Technologies Ltd Page 192
Bit 0 - Channel Out 0
Bit 1 - Channel Out 1
Bit 2 - Channel Out 2
Bit 3 - Channel Out 3
For example a mask value of 10, 0xa or 1010b would connect output
channels
1 and 3 to the specified input channel.
This command should be used in preference to the j0 0 command which only
permits one output channel to be connected to each input channel.
Audio Clean Feed Select jh
This command sets the clean feed audio monitoring point for Imagestore 750.
It behaves in the same way as j6, except that it operates on the clean feed.
CMD Param_1
jh %02x: Preview (as defined for
Imagestore 750 in command j6)
Audio Monitor Feed Select ji
This command sets the monitor feed audio monitoring point for Imagestore
750. It behaves in the same way as j6, except that it operates on the monitor
feed.
CMD Param_1
jh %02x: Preview (as defined for
Imagestore 750 in command j6)
Setup Audio Delay Bank jl
This command sets the DVE compensation enable and delay for a delay
bank.
CMD Param_1 Param_2 Param_3
jl %1x
Delay bank No.
%1x
DVE Compensation Enabled
0 – Disabled, 1 – Enabled
%06x
Delay (in
samples)