User manual

Automation Protocol 2D/3D DVE Commands
Miranda Technologies Ltd Page 123
CMD Param_1 Param_2 (Optional)
W7 %03x : Duration
1 = Default
%1x: DVE Mask (Imagestore 750 only)
0x1=Program, 0x2=Preview,
0x3=Program and preview
Run Sequence in Reverse W8
Runs the currently loaded sequence in reverse over a specified duration.
Setting the number of frames/fields to 1, runs the sequence at the speed it was
designed at. Maximum duration is 999 (0x3E7). The duration depends on the
product and standard, as defined within the W2 section. The DVE mask
option is available for Imagestore 750 only, and is as defined within the W2
section.
CMD Param_1 Param_2 (Optional)
W8 %03x : Duration
1 = Default
%1x: DVE Mask (Imagestore 750 only)
0x1=Program, 0x2=Preview,
0x3=Program and Preview
Select 2D/3D DVE Preview Configuration WP
This command only applies to Imagestore 750 and sets a DVE configuration
for the Preview channel – (it is equivalent to the W1 command which only
applies to the Program channel)
Note: Changing the DVE configuration can cause instant changes in
program output as it also affects keyer priorities.
CMD Param_1
WP %02x: Configuration Mode
The modes available are as follows:
Mode Description Preview Video Inputs
(channel 1&2)
Preview Video
output position
0x0 None (delay) - 1 frame
audio/video delay
- -
0x4 Enabled A & B K1K2 DVE K3K4
K1 DVE K2K3K4
DVE K1K2K3K4
0x9 Bypass - -