User manual

Installation Imagestore HDTV User Manual
Page 212 Miranda Technologies Ltd
The previous diagram shows the positions of the optional video and audio
input boards and the video relay bypass board.
To add or replace a plug in circuit board first switch the unit off by removing
both IEC mains leads and remove any cabling necessary for access.
To remove a blanking panel undo the 2 off M3 retaining screw positioned top
and bottom.
Observing anti-static handling procedures carefully position the board into
the chassis between the upper and lower fixing rails, aligning the base of the
printed circuit board into the card guide. Gently push the board into the
chassis until the edge connector engages with the connector on the
motherboard, taking care not to damage components fitted to the board
against adjacent metalwork. Once engaged push firmly so the plate then fits
against the rails and the fixing holes align. Refit the M3 fixing screws.
Refit cabling then apply mains.