User manual

Imagestore HDTV User Manual Overview
Miranda Technologies Ltd Page 143
The factory default option is disabled and should only modified in
consultation with your IT department.
To adjust the number, refer to the IP Address section (see above).
Pressing the enter key to accept the change will then display the message
‘Updating EEPROM’ shortly followed by ‘Please Restart For New
Network Mask’.
Restart the Imagestore HDTV.
NTP Server
This option allows the clock in the IS HDTV to be set from a Network Time
Protocol server located on the network.
Using the arrow control keys enter the IP address of your NTP server. (See IP
Address).
The number is in four blocks separated by full stops i.e.
- >255<255.255.255 +
Time Zone
Use this option to set the timezone offset from GMT (+/-) in hours, minutes
and seconds.
Console Blanking
Console Blanking acts as a screen saver if a PC monitor is attached via the
VGA connector of the CPU board.
Use the arrow control keys ⊳  to set either Disabled or between 1 – 60
minutes. At the allotted time the output to the monitor will be switched off.
To turn it back on either press a key on the PC keyboard (if connected) or
reset the time interval.
Restart System
Restarts the systems maintaining user setting. Press enter to confirm.