User manual

Imagestore User Manual Front Panel Operation
Miranda Technologies Ltd Page 67
Setting Transition Rates
The "transition rates" feature is used to set the number of frames that it will
take to complete a "fade" action or the number of frames that it will take to
complete a "FTB on/off" action.
Select manual/operate/midground or foreground/transition rates from the
boot-up menu to locate the feature.
When transition rates is selected and applied, two further options become
available from the Adjust MG Rates or Adjust FG Rates menus; these are the
fade rate and the FTB rate. Select the appropriate option using the arrow keys
W X and apply the selection using the enter key.
Change the current setting using the left and right arrow keys W X to adjust
the appropriate frame rate up or down. Press the enter key to apply the new
setting. Pressing the escape key will exit the menu leaving the original value
unchanged.
Setting the Preview Output
In Cascade mode, the Preview output may be "attached" to any one of ten
monitor points around the unit.
Select manual/operate/preview output set from the boot-up menu to locate
the feature.