User manual

Front Panel Operation Imagestore User Manual
Page 44 Miranda Technologies Ltd
VFD display, which remains showing the same menu selection for further cut
swap operations.
Fade Swapping Images
The Fade-Swap feature causes the image on air to be replaced with the image
in the preview store, and vice versa at a rate determined by the transition rate
setting described later. The on air image is faded down, swapped and then
faded back up with the new image.
Select manual/operate/programme/fade swap from the boot-up menu to
locate the feature.
Press the enter key to action a fade-swap. When the operation takes place,
the arrow may change from ↓ to ↑. During the transition the arrow is
replaced by the intermediate state symbol – acknowledging the fade is taking
place. No other change can be detected on the VFD display, which remains
showing the same menu selection for further fade swap operations.
Cut Up/Down
If an image is on air, the cut up/down feature can cause the current image to
be taken from air, and when cleared, a subsequent command will take the
image to air. The cutting action is instantaneous.