User manual

Installation and Integration Imagestore User Manual
Page 196 Miranda Technologies Ltd
to the "boot-up" menu press the escape key repeatedly. To change the setting,
use the arrow keys so that the new setting is displayed and press the enter
key to apply it.
Reference Source Selection
To operate as part of a broadcast system, or to operate stand-alone,
Imagestore digital video frames must be synchronised to a reference source.
Miranda Technologies Ltd recommends the use of a common analogue
"black and burst" reference source. Once the initial phase-lock has been set
up, phase locked loop circuits within the Imagestore automatically maintain
the synchronisation.
The alternative to a common analogue reference source is to use the
background SDI signal as the source of timing. This may be more suitable
where the unit is used within a simple presentation system.
To check or change the setting, choose Select Reference from the System Set-
up menu and press the enter key. The current setting is shown enclosed in
brackets. To return to the "boot-up" menu, press the escape key repeatedly.
To change the setting, use the arrow keys W X to display the new setting and
press the enter key to apply it.
Serial Comms Set-up
To view or change the serial comms baud rates for RS-232 and RS-422
select Serial Comms Set-up from the System Set-up menu then press the enter
key. Use the W X arrow keys to select the required port then press the enter
key. To adjust the baud rate use the W X arrow keys to scroll through the
listed values, once selected press the enter key to accept the change. To
return to the "boot-up" menu, press the escape key repeatedly.
To select Automation or an EAS model use the RS232 Protocol menu.
Aspect Ratio
Selects between 4x3 and 16x9 aspects ratios.