User manual

Installation and Integration Imagestore User Manual
Page 190 Miranda Technologies Ltd
Load System Codes
The Load System Codes feature is used to provide for the entry of "licence"
codes that enable specific options such as "Edit Pack" and "Bugclock". The
Miranda Technologies Ltd support team will provide full installation and
operation instructions at the time of issue of a licence. Licences are typically
issued as files and may be provided on a 3½" disk or via e-mail. If received
by e-mail, transfer the file or files to a blank DOS formatted disk and place
the disk in Imagestore's FDD.
Installing system codes
To install system codes from a supplied floppy disk:
♦ insert the floppy disk in the Imagestore floppy drive
♦ choose Load System Codes from the Setup/File front-panel menu
To install system codes from an email file (syscodes.txt):
♦ transfer the email file (syscodes.txt) to a blank DOS formatted floppy
disk
♦ insert the floppy disk in the Imagestore floppy drive
♦ choose Load System Codes from the Setup/File front-panel menu
To create and install system codes:
♦ create a file called syscodes.txt (using a text editor)
♦ edit the file to include the required entry/entries from the list below and
then transfer the file to a floppy disk
♦ insert the floppy disk in the Imagestore floppy drive
♦ choose Load System Codes from the Setup/File front-panel menu
The SYSCODES.TXT file can include one or more of the following entries:
IP_ADDRESS sets up the machine’s IP address (for Ethernet
access via Miranda Technologies Ltd’s MDS
system)
SUBMASK sets up the machine’s IP submask (for Ethernet
access via Miranda Technologies Ltd’s MDS
system) default = 255,255,0,0